1. Cooling water with sufficient cooling capacity is required inside the mold, which can generally be calculated by formula. The cooling mode of Guangzhou Honda's mold is to inject cold water at 18 ~ 22 ℃ for cooling, with a flow rate of about 120 ~ 150L / min;

2.树脂在进入模腔过程中，需经过带加热装置的热流道和热喷嘴，保持温度为180~220℃；

2. When the resin enters the mold cavity, it needs to pass through the hot runner and hot nozzle with heating device to maintain the temperature at 180 ~ 220 ℃;

3.需根据产品CAE分析的困气情况，在模具适当的部位开排气槽；

3. According to the trapped gas analyzed by product CAE, an exhaust slot shall be opened at the appropriate part of the die;

4.考虑抽芯机构的速度，油压一般选用70~80kg/cm2；

4. Considering the speed of core pulling mechanism, the oil pressure is generally 70 ~ 80kg / cm2;

5.考虑冷却效率及防止模具漏水，一般水道离产品距离为30~80mm。

5. Considering the cooling efficiency and preventing mold water leakage, the distance between the water channel and the product is generally 30 ~ 80mm.

快速成型降低了人工成本

Rapid prototyping reduces labor costs

（1）成型全过程的快速性，适合现代激烈的产品市?。?/div>